guitar tilt sensor help

[jgranto]

I experienced the strum bar issue, took apart the guitar, then found the thread with the fix. I fixed the issue, but as I put the guitar back together, noticed a loose part. I _think_ the part is for the tilt sensor; it is a small plastic cube, about the size of a small Lego... 1cm x 1.2cm x 0.8cm (more or less), with a single small plastic nub on one side. I cannot for the life of me see where this piece goes. Can someone help me out? Basically, I need a someone to provide a picture of the guitar interior with a "YOUR PART GOES HERE" sign...

Attached is a picture of the part (next to a penny for scale).

[Dietz]

Ha Ha I did the same thing. I couldn't figure it out until I opened up a second guitar. It's not part of the tilt sensor. It's just a spacer. Looking at the back of your guitar it goes in the top right corner. Look for a hole in the outer casing.

[AVC808]

this is why people shouldnt be taking apart their guitars :) but yeah, early on when members were posting their findings opening it up, it was mentioned this little black piece fills a hole in the casing. if you were to close your guitar up and examined the edge of the body closely you will find a tiny circle. that's what the nub is for.