Bestles Drum Kit

[Claire_m75]

OK..I'm a girl LOL I cant get the drums set up right.Is anyone else having a problem or is it just me being stoooopid LOL

I'm having a problem getting the legs sorted, they wont fit correctly:confused:

Any help anyone can give me would be fab...thank you!


*edited*
I'm such a tool...i can spell Beatles honest i can....going back to my corner now lol

[DMSTEPHENS]

Lol. I'll try explain as best I can. The thick tube has the black plastic at the top, and the thin 1 goes inside with the black bit at the bottom. Adjust to the size you want and use the clip on the thick piece to hold it in place.

[Daytrip]

Here is a link to the RB1 drums. If I remember right assembly was similar the only change being the bars that the pedal clips onto. Also there is a picture of the RB2 set.

http://www.wired.com/gamelife/2007/10/how-to-assemble/

http://www.breakitdownblog.com/wp-content/uploads/2008/09/rock-band-2-drums-pads.jpg

[RoboEnigma]

I'm having the same problem and I've assembled both the RB1 and RB2 drums before. It seems the adjustable section is stuck...inside the bigger section? I can't figure this out. Any help?

[Bront20]

The thicker parts of the legs go on the bottom, thinner on top. The holes in the actual drums go over the legs.

Or you can stick the drums directly into the feet and play them on a table.

[RoboEnigma]

Yes, I know. Let me say it this way. I'm not able to adjust ANYTHING. With RB2 I could slide the thing around, with this...nothing...is there something I'm missing? I pulled the latch out already.

[RoboEnigma]

UPDATE: I think I got it, the plastic on the thing is preventing it from moving. So, undo the latch, and push the tiny black end through. Sorry a bit hard to explain, because I'm going to play now.

But basically, undo the latch and push the small one up through the thick one. I hope it works for ya, it worked for me, and I had to push HARD.

[DMSTEPHENS]

Did you pull all of the plastic bag out from the insides? Most of the bag on mine was inside, its possible some could be caught, stopping you from adjusting?

[niff74]

Help... I'm also having a problem - kinda hard to explain but while the narrow part of the legs does fit in with the wide part, latch is sealed, there's some sort of a black plastic cap on the top of the narrow legs that won't fit in the drum part. Am I supposed to take it off somehow? the attached manual doesn't have this cap on the graphics. Kinda embarrassing... I never have problem with IKEA stuff, honest!

[ChuckandDave]

I saw some unboxing videos on YouTube. Could this help?

http://www.youtube.com/watch?v=ScHAqmWKFVo

[niff74]

I saw some unboxing videos on YouTube. Could this help?

http://www.youtube.com/watch?v=ScHAqmWKFVo

Thanks, ChuckandDave, you're a life saver! (and I'm a major doofus...)