Drum Sensor plugs broken

[Pokemans]

I have RB2 for the xbox 360, my drums are EL. My red drum hasn't been working at all and the rubber padding actually ripped off. I decided to try to connect my green drum to the red to see if it would still work, therefor only needing to replace one drum instead of buying a whole new set

When I went to disconnect the sensor in the red drum, I accidentally took out the whole piece connecting to the plastic base, instead of a small plug

It was only hooked into a green plate by two small pins

Is there any way I can replace or fix this?
Pictures:
http://i34.tinypic.com/2eo8pq0.jpg
http://i37.tinypic.com/6s9dv9.jpg
http://i38.tinypic.com/2a4pumv.jpg
http://i34.tinypic.com/6izn00.jpg

[Doc_SoCal]

Welcome to the Rockband Forums.

I cant see a thing in those pics but I will guess thatyou ripped the plug sockets from the little circuit boards that reside under each pad because the plug is actually glued to the socket.

You can solder the wires directly to that little PCB where those pins were and they will work fine if you have a soldering iron. Just be a little more patient than you were when unplugging the pads. ;)

[Pokemans]

Thanks, you were right about what happened. And I don't have a soldering Iron but I guess I'll look into it.